1967-1968 Camaro Wiring Harness

Painless Wiring 20101 1967 1968 Camaro wiring harness wiring harness.

Painless Performance Products 20101 wiring harness uses a pre-wired factory style bulkhead connector that plugs into the fuse block through the firewall in the stock location.

Easy to install, factory original, quick connect terminals are included for the in dash printed circuit board.

Pre-terminated plugs for the ignition and turn signal switches are included.

Features 18 circuits.

NOTE: For 1967 Camaro RS use of Painless 30818 headlight harness is required.

HEADLIGHT SWITCH WIRES INCLUDE:

Power to headlight switch

Power wires out of headlight switch to headlight dimmer switch, tail lights

dash lights

park lights

DIMMER SWITCH WIRES INCLUDE: power from the headlight switch and power out to low and high beam headlights.

WIPER SWITCH WIRES INCLUDE: Power to wiper switch and the wires between the wiper switch and the wiper motor.

TURN SIGNAL SWITCH WIRES INCLUDE: Power into and out of your column mounted turn signal switch. Also included in this kit are both styles of GM turn switch connectors. These will also connect to most aftermarket steering columnns as well.

IGNITION SWITCH WIRES INCLUDE: Power into and out of the fuse block (ignition, crank and accessory).

BRAKE SWITCH WIRES INCLUDE: Power into and out of the brake switch. This includes a third brake light wire.

COURTESY LIGHTS WIRES INCLUDE: Power and ground circuits for dome light activation.

ALTERNATOR WIRING INCLUDES: Charge wire and alternator field activation wires. Included in this kit is a high output alternator wire that allows you to use up to a 140 amp alternator.

HORN: 40 amp horn relay mounted to the fuseblock.

HEAT/AC WIRING INCLUDES: Power into switch and wires between switch and blower motor/resistor block.

RADIO WIRING INCLUDES: Harness includes constant B+ (for preset memory) and ignition hot circuits for any aftermarket or factory radio. Also included are two pairs of speaker wires.

STARTER WIRING INCLUDES: Crank signal wire for starter solenoid.

ENGINE SECTION WIRING INCLUDES:

electric choke

coil power

coil to tach signal

oil pressure

engine temperature

A/C compressor clutch control wire

HEADLIGHT SECTION WIRES INCLUDE:

right and left high and low beam headlights

turn signal lights

park lights

TAIL SECTION WIRES INCLUDE:

tail lights, brake lights

turn signal lights

fuel gauge sender

third brake light

reverse lights

DASH PANEL SECTION WIRES INCLUDE:

fuel

temperature

oil pressure

voltage

tahcometer

speedometer

high beam and turn indicators

gauge illumination

DOOR SECTION WIRES INCLUDE: power windows and power locks

ACCESSORY SECTION WIRES INCLUDE:

cruise control

power antenna

electric fuel pump

cigarette lighter/accessory output

ALSO INCLUDED IN THIS KIT:

fuseblock mounting bracket

rubber grommet

4" zip ties

70 am maxi fuse

large assortment of crimp style connectors

Most important of all an illustrated installation manual that equips you with the needed information to install the harness to your vehicle. If you get stuck during the installation, just call the Painless tech line. They have an immense data base of vehicle specific information.

Painless Wiring 20101 1967 1968 Camaro wiring harness PAINLESS-PERFORMANCE-20101$639.97
PayPal Acceptance Mark




We welcome CANADIAN customers! For ordering information, click on "Orders To Canada" at the top left side of this page.

We will not ship to freight forwarding - expediting companies.

PAYMENT METHODS: PayPal, Visa, Mastercard, Discover, American Express, money orders.

ecommerce provided by Yahoo! Small Business